Hand strap
Attaching the hand strap
Note
•
Take care as there is a risk of the unit dropping when the hand strap is loose.
•
Do not use the hand strap if it is worn out or damaged.
•
Before use, make sure that the screws are securely tightened. If the screws are loose, contact the service provider.
•
The design of the hand strap and the position where the hand strap is attached vary depending on the unit model.
1.
Pass the belt of the hand strap through the hand strap attachment section (the dotted circle shown in the illustration below).
2.
Adjust according to the size of your hands, then fold over and fasten the belt.
3.
Securely close the pad.
•
The top part of the pad can be used as a pen holder.
Removing the hand strap
Note
•
Do not remove the screws of the hand strap and corner ring.
1.
Open the pad of the hand strap () and unfasten the belt ().
2.
Pull out the belt from the hand strap attachment section (the dotted circle shown in the illustration below).